Line Connected To A Dti - Nortel ICS Install Manual

There are two more programming settings that must be
assigned before a line pool can be used:
• You must assign line pool access to telephones in
Line access programming.
• You must assign system-wide line pool access codes in
System prgrming for line pools A to 0, and/or routes and
destination codes. PRI line pools can only be accessed by
being assigned to routes and destination codes.
Tips -
automatically for an idle line from several lines appearing on
the telephone. Assign a line pool as the prime line
(in Line access) and all the lines in the line pool must
appear on that telephone.
When the user lifts the receiver or presses the handsfree
button, any one of the lines, if idle, can be selected by
Automatic Outgoing Line selection.
This is not available for PRI line pools.

Line connected to a DTI

The Line setting shows the trunk type for a line.
For lines connected to a DTI, press CHANGE to select one of
these settings: Loop, E&M, DID, Ground, Fixed, PRI.
• Loop is used for loop start trunks
• E&M is used for the first two line numbers on E&M trunks
Tips -
two DTMF receivers (instead of four lines, as in a Loop Start
Trunk Cartridge). For example, if an E&M Trunk Cartridge
has the range of line numbers 049 to 052, numbers 049 and
050 are E&M lines, and numbers 051 and 052 are the DTMF
receivers. The display for line 050 appears as Line050:E&M
and for line 051 appears as Line051:DTMF.
N0130943 02
A telephone can be administered to search
E&M Trunk Cartridges have two E&M lines and
Lines / 365
Modular ICS 7.1 Installer Guide