Name - Nortel ICS Install Manual

1. Place the programming overlay over the appropriate keys
on your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ¤flfl‹›› (CONFIG). The display shows
Terminals&Sets.
4. Press ' until the display shows Lines.
5. Press ≠. The display shows Show line _____.
6. Press FIND until you reach the line to which you want to
define a ring pattern.
7. Press ≠ and then ' until the display
shows TrunkType:PRI.
8. Press ' until the display shows Dstnct ring:
NONE.
9. Press CHANGE to toggle to the ring pattern number you
want to assign to the line (None, 2, 3, 4).
10. Press ® to exit or ' to continue programming.

Name

The default name for a line is Line XXX, where XXX is the
three-digit line identifier. For example, Line 001.
This can be changed to any combination of letters and numbers
to a maximum length of seven characters.
For more information, refer to Modular ICS 7.1 System
Coordinator Guide.
N0130943 02
Lines / 377
Modular ICS 7.1 Installer Guide