Kim Not Working; Cold Starting The Kim - Nortel ICS Install Manual

5. Ensure that the music source is turned on, is operational,
and the volume control is set properly.
6. Any music source with a low-output impedance, less than
3,300 Ω, can be connected. The output level must be less
than one volt.

KIM not working

The key interface module (KIM) that attaches to a 7316E
digital phone to create a central answer position (CAP) can be
reset in two ways.
• If you want to maintain the programming, you can warm
start the module by physically unplugging the module
from the telephone. When plugged back in, the module
will perform a startup. Try this first when you receive an
Addon error message on the telephone display.
• If you want to restart the module and erase the
programming, you can perform one of two cold starts
described below.

Cold starting the KIM

If the KIM does not recover after a warm reset, or if you want
to reset the programming for the KIM, there are two types of
cold starts for the modules:
For both types of cold starts:
1. Unplug and replug the 7316E line cable.
The telephone restarts and all the icons flash.
When the telephone icons stop flashing, the KIM module
icons start flashing.
N0130943 02
Problems with optional equipment / 609
Modular ICS 7.1 Installer Guide