Full Autohold; Losspkg - Nortel ICS Install Manual

372 / Lines
Tips -
Services to ring for a line placed into a scheduled Ringing
service. See the Modular ICS 7.1 System Coordinator Guide
for more information.

Full AutoHold

Full AutoHold on idle line is a variation of the Automatic Hold
feature. If you select an idle line, but do not dial any digits, that
line is automatically placed on hold if you select another line.
Press CHANGE to select the setting: N (No) or Y (Yes).
The line you first selected is held until you press the line
button. The line is not available for use by anyone else.
Tips -
start trunk programming. Full AutoHold is always in place for
E&M trunks, but it has no meaning for incoming-only DID
trunks. Only change the default setting if Full AutoHold is
required for a specific application.

LossPkg

Loss Package allows you to select the appropriate loss/gain
and impedance settings for each line. The setting is based on
the distance between the ICS and the terminating switch, and
the terminating switch type. When measuring the distance
from ICS to CO and from ICS to PBX, use 600 ohms as the
termination resistance setting.
A loss of 4 dB corresponds to a cable length of approximately
2700 m (9000 ft.).
Press CHANGE to select one of the following settings.
Modular ICS 7.1 Installer Guide
An auxiliary ringer can also be programmed in
The Full AutoHold setting appears only during loop
N0130943 02