Setting Up Wireless Communications; General; Display Current User - Intermec EasyCoder PF2i Installation Instructions Manual

Chapter  — Setup in Fingerprint

Setting Up Wireless Communications

This section describes how to perform some common tasks such as
changing user and passwords, as well as setting individual network
parameters with Fingerprint commands.

General

Once a wired serial communication is established, you can use
Fingerprint setup strings or setup files to set up the necessary EasyLAN
Wireless parameters. All settings are saved in files on the printer flash
memory. If a factory default upgrade is performed, all settings described
in this section are reset to (factory) default values.
admin
The default allowed user is . All settings are restricted to read-
only for all users except the allowed user, who can change all settings. If
unauthorized access is attempted, error 1076 (Operation not permitted)
will occur. Settings beginning with a period "." character are read-
protected from non-authorized users. Some settings are not possible to
read even by the allowed user, for instance WEP keys, which return the
same string regardless of the actual key.

Display Current User

To display who the current user is in Fingerprint, the "whoami"
command is used.
Syntax:
RUN"whoami"
Note: This command is case-sensitive.
The command echoes the current user to the standard out channel.
Example:
RUN"whoami"
user
Ok
0 EasyLAN Wireless Interface Kit Installation Instructions