Charging The Battery - Contax U4R Manual

Introduction

Charging the Battery

A Important
Ensure that the battery pack is inserted in the camera before charging.
1
Place the camera in the USB cradle.
BNote
2
Plug the AC adapter into the USB cradle
to charge.
Charge time is approximately 4 hours.
Turn the camera off during charging.
The caution LED (red) turns on when the camera is charging and turns
off after approximately 3 hours, at which point the battery pack is 90%
charged.
Leaving the AC adapter connected for approximately one hour more
charges the battery pack fully.
A Important
• When you first purchase the camera, you need to charge the battery fully.
• If the battery pack is repeatedly charged with the battery pack or camera containing the
• Remove the camera from the USB cradle and turn the power on to check the camera
B Note
The AC adapter supports voltages of up to 240 V. When you are charging the camera in a
foreign country, use the AC adapter cable that matches the voltage and power socket of
that country. You do not need to use a voltage transformer or other devices.
Contents Glossary
Getting Ready Taking Pictures
Refer to "Using the USB Cradle" (
details on attaching the USB cradle.
battery left in a hot location, the battery pack will deteriorate, reducing the number of
photos that can be taken. When this occurs, replace the battery pack with a new one.
battery level. ( p.33)
Index
Playback
p.36) for
EN-29
Nomenclature
Set Up
BACK NEXT
Menus and Settings Troubleshooting