Contax U4R Manual page 188

Introduction Getting Ready
Problem
The number of
available shots
did not increase
after I erased an
image.
I cannot charge
the battery.
I cannot charge
the battery. Or
charging stops.
The caution LED
flashes slowly.
The camera
feels hot.
The caution LED
flashes slowly.
The caution LED
flashes quickly.
The camera will
not focus. The
shooting mark
flashes.
Contents Glossary
Taking Pictures
Cause
This is because the erased
image size was small.
There is no lithium-ion
battery pack loaded in the
camera.
The lithium-ion battery pack
poles (+ and -) are the wrong
way round.
The AC adapter is not
connected correctly.
The battery pack terminals
are soiled.
The charging protection
circuit was activated and
halted charging because the
ambient temperature is too
high or too low.
Because the LCD monitor
uses relatively large amounts
of current, the camera grows
warm after prolonged use.
The flash is charging.
This is the camera shake
warning. The shutter speed
is slow.
The subject is a type that is
not suited to auto focus.
Index
Playback
This is dependent on factors
such as the number of pixels
and the subject and is not a
problem.
Load a lithium-ion battery pack
into the camera.
Reload the lithium-ion battery
pack correctly.
Check that the adapter is
securely connected to the
camera and the power socket.
Wipe the terminals with a soft
clean cloth.
Charge the battery when the
ambient temperature is between
10°C and 30°C.(Charging is
possible between 5°C and 40°C
but will take slightly longer.)
This is not a problem, but you
should shut the camera down for
a few minutes.
Briefly take your finger off the
shutter release button and wait.
Place the camera on a stable
surface to take the picture.
Use focus lock to focus on a
strongly contrasting part of the
subject, then compose the shot
and take the picture.
EN-188
Nomenclature
Set Up
Solution
BACK
Menus and Settings
Page
-
27
27
29
-
-
-
26
26
75
NEXT
Troubleshooting