Bright Cntrl] Adjusting The Lcd Monitor Brightness - Contax U4R Manual

Introduction

[BRIGHT CNTRL] Adjusting the LCD Monitor Brightness

You can adjust the LCD monitor brightness through 5 levels. Set the
brightness to your preferred level.
1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
2
Move the selector lever up u or down d
to select [BRIGHT CNTRL], then move the
lever right r.
3
Move the selector lever up u or down d
to select the brightness, then press E.
The selected brightness is applied.
[+2] : Sets the maximum brightness.
[+1] : Sets the brightness slightly higher than normal.
[STANDARD] : Normal level of brightness. (Default)
[-1] : Sets the brightness slightly lower than normal.
[-2] : Sets the minimum brightness.
B Note
This setting is retained when you turn the camera off.
Contents Glossary
Getting Ready Taking Pictures
Index
Playback
EN-164
Nomenclature
Set Up
SET UP(1/3)
AF MODE SAF
FORMAT EXECUTE
BRIGHT CNTRL STANDARD
DATE 2004.01.01
INSERT DATE NO DATE
POWER SAVE 1MIN.
SET UP(1/3)
+ 2
AF MODE
+ 1
FORMAT
BRIGHT CNTRL STANDARD
– 1 – 1
DATE
– 2 – 2
INSERT DATE
POWER SAVE 1MIN.
Menus and Settings Troubleshooting