Contax U4R Manual page 175

Introduction
5
Move the selector lever left l or right r
to select an image and press E.
A number is displayed in the lower left of the selected image. Repeat
this procedure to select more images for the startup screen.
BNote
6
Press the SCENE button I.
A message appears asking you to confirm the image setting.
BNote
7
Move the selector lever up u to select
[SET], then press E.
The selected image is stored in the internal camera memory.
The user-defined screen setting is set and the startup screen is
displayed for 1 second, and then the SET UP menu screen reappears.
B Note
• This setting is retained when you turn the camera off.
• Because the selected images are stored in the camera's memory, switching memory
Contents Glossary
Getting Ready Taking Pictures
You can select a maximum of 10 images. If you
have selected 10 images, continue on to step 7.
Once you have selected more than 6 images, you
can move the selector lever left l or right r to
check the remaining images.
cards or erasing the image from the memory card does not affect the images shown in
the startup screen.
Index
Playback
EN-175
Nomenclature
Set Up
SELECT IMAGE
0001/0051
1 1
SELECT OK
APPLY SETTINGS?
1 1 2 2 3 3
4 4 5 5 6 6
SET
CANCEL
BACK NEXT
Menus and Settings Troubleshooting