To Set A User-Defined Screen (Single) - Contax U4R Manual

Introduction
3
Move the selector lever up u or down d
to select [SINGLE] or [MULTI], then press
E.
4
Move the selector lever left l to select
the CONTAX logo screen, then press E.
The CONTAX logo screen is configured, and an example of the startup
screen is displayed for 1 second before returning to the SET UP menu
screen.
B Note
This setting is retained when you turn the camera off.

To set a user-defined screen (SINGLE)

A Important
Check that the memory card containing the images you want to use is inserted into the
camera.
1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2
Move the selector lever up u or down d
to select [START SCREEN], then move the
lever right r.
Contents Glossary
Getting Ready Taking Pictures
Index
Playback
EN-172
Nomenclature
Set Up
SELECT START SCREEN
SINGLE
MULTI
OFF
SELECT START SCREEN
SELECT IMAGE
OK
SET UP(2/3)
+ 2
BEEP
+ 2
SHUTTER VOL
DIGITAL ZOOM ON
START SCREEN SET
2SEC
REC REVIEW
LANGUAGE ENGLISH
BACK NEXT
Menus and Settings Troubleshooting
RESET