Ending Pictbridge - Contax U4R Manual

Introduction
2
Move the selector lever up u to select
[EXECUTE], then press E.
A message appears asking you to confirm that you want to print the
images.
Refer to "Specifying the print settings" (
settings.
BNote
3
Move the selector lever up u to select
[EXECUTE], then press E.
Printing begins, and when printing is successfully completed, the print
completion screen appears.
A Important
BNote

Ending PictBridge

Wait until the print menu screen is displayed, then disconnect the USB
cable.
Contents Glossary
Getting Ready Taking Pictures
Press the MENU button K to display the print
menu screen.
If an error occurs during printing, an error
message is displayed and printing stops. Refer to
p.190 for information on the message displayed
and the correct response.
• You can specify the print settings by clicking the
SCENE button I before proceeding with this
step. (See steps 2 to 12 on p.130 for information
on the setting procedure.)
• The number of copies and date imprinting
settings are not shown because the DPOF
settings take precedence.
• During printing, a counter on the LCD monitor
displays the total number of prints and the
number of prints completed so far.
• Press the MENU button K to stop printing in
progress.
Index
Playback
p.130) to change print
EN-135
Nomenclature
Set Up
DPOF PRINTING
DPOF 3 PRTS
INDEX SET OFF
EXECUTE
CANCEL
EXECUTE PRINT?
PRINT QTY. ––––
PAPER SIZE
2L
PAPER TYPE PHOTO
BORDERLESS YES
DATE ––––
EXECUTE
CANCEL
BACK
Menus and Settings Troubleshooting