Insert Date] Adding The Date To Images - Contax U4R Manual

Introduction

[INSERT DATE] Adding the Date to Images

You can choose to imprint the date on images.
1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
2
Move the selector lever up u or down d
to select [INSERT DATE], then move the
lever right r.
3
Move the selector lever up u or down d
to select [NO DATE] or [WITH DATE], then
press E.
The selected setting is applied.
A Important
If you set [DATE] to [PRINT] in [DPOF] (
with [INSERT DATE] set to [WITH DATE], the date will appear twice on the prints.
B Note
• This setting is retained when you turn the camera off.
• When [INSERT DATE] is set to [NO DATE], the date is only shown for 3 seconds when
• The date is written on the bottom right of the image. It is not possible to erase the date
• The date may be difficult to read if the background in the section where the date is
Contents Glossary
Getting Ready Taking Pictures
the camera is turned on.
from an image.
written is bright white or yellow.
Index
Playback
p.123), then print photographs that were shot
EN-165
Nomenclature
Set Up
2004.09.01
SET UP(1/3)
AF MODE SAF
FORMAT EXECUTE
BRIGHT CNTRL STANDARD
DATE 2004.01.01
INSERT DATE NO DATE
POWER SAVE 1MIN.
SET UP(1/3)
AF MODE SAF
FORMAT EXECUTE
BRIGHT CNTRL STANDARD
DATE 2004.01.01
INSERT DATE NO DATE
POWER SAVE WITH DATE
Menus and Settings Troubleshooting