Contax U4R Manual page 173

Introduction
3
Move the selector lever up u to select
[SINGLE], then press E.
4
Move the selector lever left l or right r
to select the center location, then move
the lever down d.
The image selection screen appears showing the still images stored on
the memory card.
BNote
5
Move the selector lever left l or right r
to select an image and press E.
A message appears asking you to confirm the image setting.
6
Move the selector lever up u to select
[SET], then press E.
The selected image is stored in the internal camera memory.
The user-defined screen setting is set and the startup screen is
displayed for 1 second, and then the SET UP menu screen reappears.
B Note
• This setting is retained when you turn the camera off.
• Because the selected images are stored in the camera's memory, switching memory
Contents Glossary
Getting Ready Taking Pictures
If you select [RESET], the reset confirmation
message appears. Select [EXECUTE] and press
E to delete the user-defined screen set previously
from the camera's memory.
cards or erasing the image from the memory card does not affect the images shown in
the startup screen.
Index
Playback
EN-173
Nomenclature
Set Up
SELECT START SCREEN
SINGLE
MULTI
OFF
SELECT START SCREEN
SELECT IMAGE
OK
SELECT IMAGE
0001/0051
OK
APPLY SETTINGS?
SET
CANCEL
BACK NEXT
Menus and Settings Troubleshooting
RESET