Loading And Charging The Battery Pack.15 - Contax TVS DIGITAL Instruction Manual

1. Loading and Charging the Battery Pack
1
2
RattS'V pack
A' mark
Camera
mark
Battery pack
Better^' stc^^r
<Loading the battery pack>
^ Open the battery pack cover.
Stide i! open as shown In itis figure.
2
Slide in the supplied battery pack until the
battery stopper locks in place.
Align the ' mark on the camera with ihe
"A"
mark on
the battery pack to ensure correct loading.
• ln« battery pack cannot be cnarged it >t is loaoed upside-
Oown.
^ Close the battery pack cover.
<Removing the battery pack>
Release the battery stopper lock to remove the banery
pack.
Power supply input connector
<Charging status>
<Charging the battery pack>
Load the battery pack in the camera, connect the
supplied AC adapter to the power supply Input
connector on the camera.
• Make sure that the camera «turneC off Oetore cnargmg
It takes about 6 hours to charge the battery pack.
The Caution l.ED (Red) is lit dunng charging. When the
battery pack is fully charged, the Caution LED goes out
and the Standby LED (Green) lights.
StarCOy LED
(Greenl
Use the battery indicatw on the LCD monitor to check whether or not the battery pack nwds to be
•charged.
[jr
[pTi|
[{Bn|
Sufbcienr battery poiver
Heir ot me battery
power has been used.
Battery power ts KM.
Time to charge.
No remaining chaige
and camera does not
operate. Charge the
Cattery pack.
15