Turning The Camera On; Viewing The Battery Level And Charging Guide - Contax U4R Manual

Introduction

Turning the Camera On

A Important
Check that a memory card is inserted in the camera before turning the camera on.
1
Press the POWER button H.
The startup screen is displayed for a few seconds and then the normal
screen for the selected camera mode appears.
B Note
• While the camera is turned on, press the POWER button H again to turn the camera
• You can configure whether the camera starts in still image mode when it is turned on or

Viewing the battery level and charging guide

Battery fully
charged.
When the battery charge is completely depleted, the "LOW BATTERY"
message appears on the LCD monitor.
The amount of power consumed by a digital camera varies
considerably depending on the environment in which it is being
used. Even if the battery level indicator shows that there is still
charge in the batteries, the camera may turn itself off in some
camera operating conditions. Recharge the battery if this happens.
Contents Glossary
Getting Ready Taking Pictures
off.
if it returns to same mode as when it was turned off. (
Approximately
70% used.
Index
Playback
Remaining
charge very low.
Charge the
battery soon.
EN-33
Nomenclature
Set Up
p.180)
Camera will not
operate. Charge
the battery.
LOW BATTERY
BACK NEXT
Menus and Settings Troubleshooting