Startup Mode] Setting The Mode The Camera Starts In - Contax U4R Manual

Introduction

[STARTUP MODE] Setting the Mode the Camera Starts In

The camera can be set to always start in still image mode when turned on,
or to start in the same mode as the last time it was turned off.
1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
2
Move the selector lever up u or down d
to select [STARTUP MODE], then move
the lever right r.
3
Move the selector lever up u or down d
to select the desired mode, then press E.
The selected setting is applied.
[STILL] : The camera switches to still image mode when it is turned on.
(Default)
[LOCK] : When you turn the camera on, the camera uses the mode
used last time the power was turned off.
B Note
This setting is retained when you turn the camera off.
Contents Glossary
Getting Ready Taking Pictures
Index
Playback
EN-180
Nomenclature
Set Up
SET UP(3/3)
VIDEO OUT NTSC
STARTUP MODE STILL
DISPLAY INFO ON
FILE NO. EXECUTE
MODE RESET EXECUTE
SET UP(3/3)
VIDEO OUT NTSC
STARTUP MODE STILL
DISPLAY INFO LOCK
FILE NO. EXECUTE
MODE RESET EXECUTE
Menus and Settings Troubleshooting