P] Adding Sounds To Still Images (Postrecording); Recording A Message - Contax U4R Manual

Introduction

[p] Adding Sounds to Still Images (POSTRECORDING)

«Applicable images: Still images only»
This feature allows you to add recorded voice messages to photographed
images.
B Note
• These settings can also be used in MULTI playback / GROUP playback modes
• Postrecorded audio is saved in the same folder as the image file, but with a different file

Recording a message

1
Turn the camera on and press the mode
buttons UD until "P" lights up on the
mode select LED.
2
Press the MENU button K to display the menu icons.
3
Move the selector lever left l or right r
to select POSTRECORDING [p] and press
E.
4
Move the selector lever left l or right r to select the image
to which you want to add the voice message.
Contents Glossary
Getting Ready Taking Pictures
( p.90).
extension, as shown below.
DCIM
100CXBOX
Index
Playback
KICX0001.jpg
KICX0002.jpg Image file that has had audio attached
Recorded audio file
KICX0002.wav
KICX0003.jpg
•
•
•
EN-110
Nomenclature
Set Up
POSTRECORDING
NEXT
Menus and Settings Troubleshooting