To Set A User-Defined Screen (Multi) - Contax U4R Manual

Introduction

To set a user-defined screen (MULTI)

A Important
Check that the memory card containing the images you want to use is inserted into the
camera.
1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2
Move the selector lever up u or down d
to select [START SCREEN], then move the
lever right r.
3
Move the selector lever up u or down d
to select [MULTI], then press E.
4
Move the selector lever left l or right r
to select the center location, then move
the lever down d.
The image selection screen appears showing the still images stored on
the memory card.
BNote
Contents Glossary
Getting Ready Taking Pictures
If you select [RESET], the reset confirmation
message appears. Select [EXECUTE] and press
E to delete the user-defined screen set previously
from the camera's memory.
Index
Playback
EN-174
Nomenclature
Set Up
SET UP(2/3)
+ 2
BEEP
+ 2
SHUTTER VOL
DIGITAL ZOOM ON
START SCREEN SET
REC REVIEW 2SEC
LANGUAGE ENGLISH
SELECT START SCREEN
SINGLE
MULTI
OFF
SELECT START SCREEN
SELECT IMAGE
OK
BACK NEXT
Menus and Settings Troubleshooting
RESET