Start Screen] Selecting The Startup Screen; To Set The Contax Logo Screen (Single/Multi) - Contax U4R Manual

Introduction

[START SCREEN] Selecting the Startup Screen

Use this procedure to select one of the following as the startup screen that
is displayed when you turn the camera on:
• CONTAX logo (SINGLE)
• CONTAX logo (MULTI)
• User-defined screen (SINGLE) : You can choose an image from those saved on the memory card to display
• User-defined screen (MULTI) : You can choose multiple images from the memory card to display
• OFF screen
B Note
When you turn the power on, the camera runs a check on the memory card. If there is a lot
of data stored on the memory card, the startup screen is displayed until the check
operation is finished. If the startup screen is set to MULTI, the final frame of the animation
is displayed during this time.

To set the CONTAX logo screen (SINGLE/MULTI)

1
Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2
Move the selector lever up u or down d
to select [START SCREEN], then move the
lever right r.
Contents Glossary
Getting Ready Taking Pictures
: The CONTAX logo screen is displayed for approximately 1 second.
(Default)
: The CONTAX logo animation is displayed for approximately 1 second.
for approximately 1 second.
sequentially for approximately 1 second to form an animation. (up to 10
images)
: No startup screen is displayed.
Index
Playback
EN-171
Nomenclature
Set Up
SET UP(2/3)
+ 2
BEEP
+ 2
SHUTTER VOL
DIGITAL ZOOM ON
START SCREEN SET
REC REVIEW 2SEC
ENGLISH
LANGUAGE
NEXT
Menus and Settings Troubleshooting