Pairing Input Channels - Yamaha DM1000 Owner's Manual

Pairing Input Channels

On the DM1000, you can pair adjacent odd-even Input Channels or counterpart channels
on Layer 1 and Layer 2 that share the same physical fader. Faders and most parameters of
paired channels are linked for stereo operation. Paired channels' linked parameters and
non-linked parameters (that are available for independent control) are listed below:
Linked parameters
[SEL] buttons
Faders
Channel on/off
Insert on/off
Solo on/off
Solo Safe
Aux on/off
Aux Send level
Aux Sends as Pre or Post
Gate
Comp settings
EQ settings
Fader group
Mute group
Fade time
Recall Safe
Routing settings
To pair channels, or to cancel channel pairs, you can use the [SEL] buttons on the top panel
or access the Pair/Group pages.
■ Pairing Channels by Using the [SEL] Buttons
1 While pressing and holding down the [SEL] button for one of the channels
you wish to pair, press the [SEL] button for the adjacent channel. (The paired
channel numbers should be odd and even in this order).
Note: The settings of the first channel are copied to the second channel and the channels are
paired if the Pair Confirmation check box on the Preference1 page is not checked (default).
(If the selected channels have already been paired, this procedure will cancel the pair setting.)
The Channel Pairing window appears.
Note: You can pair only channels that are adjacent, odd-even (in this order) channels. Pressing
the [SEL] button for a non-adjacent channel will be ignored. You cannot pair or cancel a pair
of vertical partners.
Pairing Input Channels
Non-linked parameters
Input patches
Insert patches
Output patches
Comp insert position
Phase
Delay on/off
Delay time
Delay feedback
Delay mix
Routing
Pan, Follow Pan
Surround pan
Aux Send pan
Balance
Attenuators
73
DM1000—Owner's Manual
6