Yamaha DM1000 Owner's Manual page 315

COMPAND 5.1
Six input, six output compander for 5.1 surround, with individual solo for each band, and
gain reduction metering of left and right (L+R), left surround and right surround (LS+RS),
center (C), or LFE channels.
Parameter
LOW GAIN –96.0 to +12.0 dB
MID GAIN –96.0 to +12.0 dB
HI. GAIN –96.0 to +12.0 dB
PRESENCE –10 to +10
THRE. –24.0 to 0.0 dB
RATIO 1:1 to 20:1
ATTACK 0–120 ms
1
RELEASE
WIDTH 1–90 dB
TYPE Soft, Hard
LOOKUP 0.0–100.0 ms
2
KEY LINK
L–M XOVR 21.2 Hz–8.00 kHz
M–H XOVR 21.2 Hz–8.00 kHz
SLOPE –6 to –12 dB
CEILING –6.0 to 0.0 dB, OFF
SOLO LOW OFF, ON
SOLO MID OFF, ON
SOLO HIGH OFF, ON
1. 6 ms–46.0 s (fs=44.1 kHz), 5 ms–42.3 s (fs=48 kHz), 3 ms–23.0 s (fs=88.2 kHz), 3 ms–21.1 s
(fs=96 kHz)
2. 5.1: Key-in's of all inputs are linked
5.0: Key-in's of L, C, R, LS, and RS are linked (LFE is independent)
3+2: Key-in's of L, C, and R, and key-in's of LS and RS, are linked respectively (LFE is independent)
2+2: Key-in's of L and R, and key-in's of LS and RS, are linked respectively (C and LFE are independent)
Range
Low band level
Mid band level
High band level
For positive values, the threshold of the high band is lowered
and the threshold of the low band is increased. For negative
values, the opposite will occur. When set to 0, all three bands
are affected the same.
Compressor threshold
Compressor ratio
Attack time
Release time
Compressor effect range and expander effect width
Compander type
Lookup delay
Key-in linking
Low/mid crossover frequency
Mid/high crossover frequency
Filter slope
Specifies the maximum output level
If this is on, only the low-frequency band will be output.
If this is on, only the mid-frequency band will be output.
If this is on, only the high-frequency band will be output.
Effects Parameters
Description
DM1000—Owner's Manual
315