Setting The Input Channels - Yamaha CL5 Owner's Manual

Patching the input port
1.
Press the I/O DEVICE button in the touchscreen.
2.
In the upper part of the I/O
DEVICE screen, press the
DANTE PATCH tab.
3.
In the I/O DEVICE screen,
press the DANTE INPUT
PATCH button.
4.
Press the AUTO SETUP button.
5.
When a confirmation dialog appears, press
the OK button.
6.
Press the X symbol to close the screen.
Patching the mixer output to the I/O device
1.
Press the I/O DEVICE button
in the display screen, then
press the Rio tab.
2.
Press the OUTPUT display area of the I/O
device that will be the output destination.
3.
Press the OUTPUT 1 button.
4.
In the PORT SELECT screen, select the output
channels you want to output to the rack.
5.
Press the CLOSE button.
6.
In the same way, set OUTPUT 2 and
subsequent outputs, if necessary.

Setting the input channels

Switching phantom power on or off
1.
Press the [SEL] key for the channel that you
want to control in the Channel Strip section
or Centralogic section.
2.
Press the GAIN knob in the SELECTED
CHANNEL section.
GAIN knob
3.
Press the +48V button in the GAIN/PATCH
popup window as necessary, depending on
the microphone you use.
➩
NOTE
• The phantom power master switch on the I/O device must
be turned on first.
• Make sure that phantom power is turned OFF unless it is
needed.
• When turning phantom power on, pay careful attention to
the following to prevent damage or noise in the mixing
console or connected equipment.
- Turn the +48 button off if equipment that does not use
phantom power is connected to the OMNI IN jacks.
- Do not connect or disconnect a cable to or from the
OMNI IN jacks while the +48 button is on.
- Set all digital mixing console output controls to minimum
when turning phantom power ON or OFF.
Adjusting the analog gain
1.
Press the [SEL] key for the channel that you
want to control in the Channel Strip section
or Centralogic section.
2.
Press the [CUE] key of the same channel.
3.
While checking the sound level through the
headphones and meters, adjust the channel
[GAIN] knob of the Channel Strip section.
4.
Adjust the gain level for other channels in the
same way, by pressing their [SEL] and [CUE]
keys, and then rotating the [GAIN] knobs.
5.
After adjustment is complete, switch the
[CUE] key off (the key LED turns off).
Setting the input channels
41
Owner's Manual