Yamaha DM1000 Owner's Manual page 313

M.BAND DYNA.
Two input, two output 3-band dynamics processor, with individual solo and gain reduction
metering for each band.
Parameter
LOW GAIN –96.0 to +12.0 dB
MID GAIN –96.0 to +12.0 dB
HI. GAIN –96.0 to +12.0 dB
PRESENCE –10 to +10
CMP. THRE 24.0 to 0.0 dB
CMP. RAT 1:1 to 20:1
CMP. ATK 0–120 ms
CMP. REL 1
CMP. KNEE 0–5
LOOKUP 0.0–100.0 ms
CMP. BYP OFF, ON
L–M XOVR 21.2 Hz–8.00 kHz
M–H XOVR 21.2 Hz–8.00 kHz
SLOPE –6 to –12 dB
CEILING –6.0 to 0.0 dB, OFF
EXP. THRE –54.0 to –24.0 dB
EXP. RAT 1:1 to :1
1
EXP. REL
EXP. BYP OFF, ON
LIM. THRE –12.0 to 0.0 dB
LIM. ATK 0–120 ms
LIM. REL 1
LIM. BYP OFF, ON
LIM. KNEE 0–5
SOLO LOW OFF, ON
SOLO MID OFF, ON
SOLO HIGH OFF, ON
1. 6 ms–46.0 s (fs=44.1 kHz), 5 ms–42.3 s (fs=48 kHz), 3 ms–23.0 s (fs=88.2 kHz), 3 ms–21.1 s
(fs=96 kHz)
Range
Low band level
Mid band level
High band level
For positive values, the threshold of the high band is lowered
and the threshold of the low band is increased. For negative
values, the opposite will occur. When set to 0, all three bands
are affected the same.
Compressor threshold
Compressor ratio
Compressor attack
Compressor release time
Compressor knee
Lookup delay
Compressor bypass
Low/mid crossover frequency
Mid/high crossover frequency
Filter slope
Specifies the maximum output level
Expander threshold
Expander ratio
Expander release time
Expander bypass
Limiter threshold
Limiter attack
Limiter release time
Limiter bypass
Limiter knee
If this is on, only the low-frequency band will be output.
If this is on, only the mid-frequency band will be output.
If this is on, only the high-frequency band will be output.
Effects Parameters
Description
DM1000—Owner's Manual
313