Solo Trim; Solo Interruption - Yamaha DM1000 Owner's Manual

E

SOLO TRIM

This parameter enables you to trim the level of the Solo signal in the range of –96 dB to
+12 dB.
F

SOLO INTERRUPTION

When this parameter is set to Off, soloed channel signals are not fed to the Control
Room Monitor outputs. To monitor the Control Room Monitor signals and soloed
channel signals separately, change the output patching so that the soloed channel signals
are output independently from the Control Room Monitor outputs, then turn the Solo
Interruption parameter to Off.
G
2TR DIN FLIP
This parameter enables you to specify the signal source that will be monitored when you
press the MONITOR [2TR D1] or [2TR D2] button.
• 2TR D1 & OMNI 1/2 ...These buttons select the 2TR IN DIGITAL 1 and OMNI IN 1/2
• 2TR D2 & OMNI 3/4 ...These buttons select the 2TR IN DIGITAL 2 and OMNI IN 3/4
H
SOLO SAFE CHANNEL
For Mixdown Solo mode, Input Channels can be configured individually so that they
are not muted when other Input Channels are soloed (Solo Safe function). Signals from
Input Channels with the SOLO SAFE CHANNEL button turned on are always fed to the
Stereo bus, regardless of the channels' Solo function status. You can clear all Solo Safe
settings by turning on the ALL CLEAR button.
Tip: For example, if you set the internal effects processor's return signal to Solo Safe, you can
monitor the soloed "processed (or wet)" signals.
I
CONTROL ROOM DIMMER LEVEL
This parameter determines the amount of attenuation applied to the Control Room
Monitor signal by the Dimmer function when you press the MONITOR [DIMMER]
button. The amount of attenuation can range from 0 dB to –96 dB.
J
MONO
This button switches the Control Room Monitor signal into mono.
Control Room Monitor and Solo Setup
inputs respectively as the signal source that will be monitored
when you press the [2TR D1] button.
inputs respectively as the signal source that will be monitored
when you press the [2TR D2] button.
117
DM1000—Owner's Manual
10