Delaying Input Channels - Yamaha DM1000 Owner's Manual

B
GLOBAL
The GLOBAL NOR/REV buttons allow you to set the phase for all Input Channels
simultaneously.
Tip:
• The name of the currently-selected channel is indicated in the upper-right corner of the
screen.
• You can set the phase separately for each channel in a channel pair.

Delaying Input Channels

To set the delay for each channel, press the [
the page listed below that contains the desired channels appears.
- DLY 1-16 page
This page enables you to set the Delay function for Input Channels 1–16.
- DLY 17-32 page
This page enables you to set the Delay function for Input Channels 17–32.
- DLY 33-48 page
This page enables you to set the Delay function for Input Channels 33–48.
The parameters on these three pages (and the procedure for setting them) are the same.
1
3
A
DELAY SCALE
The following buttons determine the units of the delay value shown below the msec
value.
• meter..............................Units are set to meters.
• feet..................................Units are set to feet.
• sample ...........................Units are set to samples.
• beat.................................Units are set to beats.
• frame..............................Units are set to timecode frames.
B
GANG button
When this button is turned on (highlighted), the delay time for each channel in a chan-
nel pair can be set simultaneously. When this option is turned off, the delay time can be
set for each channel in a channel pair individually.
Setting the Input Channels from the Display
/INSERT/DELAY] button repeatedly until
61
2
DM1000—Owner's Manual
6