Yamaha DM1000 Owner's Manual page 311

AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround.
Parameter
OFF, HOLD, INPUT1,
INPUT2, INPUT3,
SOURCE
INPUT4, INPUT5,
INPUT6, MIDI
TRG LVL –60 to 0 dB
TRG MASK 0–1000 ms
TIME 0.1 s–10.0 s
SPEED 0.05–40.00 Hz
DIR. Turn L, Turn R
OFFSET –180 to +180 degrees
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
• When you press the RESET button, the phase will be initialized to the setting of the OFFSET parameter.
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter
FREQ. 0.05–40.00 Hz
AM DEPTH 0–100%
PM DEPTH 0–100%
MOD. DLY 0.0–400.0 ms
WAVE Sine, Tri
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
SYNC OFF, ON
1
NOTE
1.
Range
Source specifies the trigger that will initiate auto pan. When
you press the TRIGGER button in the screen, auto pan will
begin regardless of the setting of this parameter.
OFF: No trigger is specified. Auto pan will always be off.
HOLD: No trigger is specified. Auto pan will always be on.
INPUT 1-6: The input signal to effect inputs 1-6 will be the
trigger.
MIDI: MIDI note-on messages will be the trigger.
If SOURCE is set to INPUT, any signal with a level greater
than the setting of this parameter will be detected as a trig-
ger.
Trigger Mask specifies the time from when a trigger is
received until the next trigger will be accepted.
The time after which autopan starts once it's been triggered
Autopan speed
Autopan direction
Pan offset
Range
Modulation speed
Amplitude modulation depth
Pitch modulation depth
Modulation delay time
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Effects Parameters
Description
Description
DM1000—Owner's Manual
311