Yamaha DM1000 Owner's Manual page 75

2 Move the cursor to the PAIR MODE parameter field (
HORIZONTAL or VERTICAL button.
The function of each mode is described below:
• HORIZONTAL.............This button pairs adjacent odd-even channels (default).
• VERTICAL ....................This button pairs counterpart channels on Layer 1 and Layer 2
When you switch the Pair Mode, the combinations of channel numbers displayed on the
page also change.
Note:
• When Pair mode is switched, only the channel numbers change. The mix parameters of the
paired partners do not change.
• For example, if you change Pair mode from Horizontal to Vertical, the Input Channel "2"
indication changes to Input Channel "17." However, its parameters do not change. (If Chan-
nels 1 and 2 have been paired, switching the mode will pair Channels 1 and 17.)
3 Move the cursor to the desired channel's MONOx2 button, then press
[ENTER].
The channels are paired.
4 To cancel a pair, move the cursor to the desired channel's STEREO button,
then press [ENTER].
Tip: You can also pair or cancel a pair of Output Channels in the same way on the Pair/Group
| Output page (see page 87).
Pairing Input Channels
that share the same physical fader (e.g., CH1 & CH17, CH16 &
CH32, etc.). This mode is useful when you wish to use one
fader to control both stereo channels.
75
1
), then select the
DM1000—Owner's Manual
6