Pairing Input Channels - Yamaha 01V96i Reference Manual

26
Input Channels
If the check box is off, the parameter value currently
being adjusted pops up.
See page 21 for more information on EQ.
Tip:
• Pressing and holding down the button selected in Step 2 resets
the corresponding band gain.
• Pressing the SELECTED CHANNEL [HIGH] and [LOW]
buttons simultaneously resets the Q, frequency and gain for
each band.
01V96i—Reference Manual

Pairing Input Channels

On the 01V96i, you can pair adjacent odd-even Input Chan-
nels or counterpart channels on Layer 1 and Layer 2 that share
the same physical fader. Faders and most parameters of paired
channels are linked for stereo operation. Paired channels'
linked parameters and non-linked parameters (that are avail-
able for independent control) are listed below:
Linked parameters
[SEL] buttons
Faders
Channel on/off
Insert on/off
Solo on/off
Solo Safe
Aux on/off
Aux Send level
Aux Sends as Pre or Post
Gate
Comp settings
EQ settings
Fader group
Mute group
Fade time
Recall Safe
* You can set this parameter for each channel indepen-
dently if the GANG button is turned off on the
/INS/DLY | DLY page.
** You can set this parameter for each channel indepen-
dently on the EQ | ATT page, but the paired channel set-
tings are linked on the EQ | Edit and View pages.
Note: You cannot pair an ST IN channel 1–4 with an Input Chan-
nel.
To pair channels, or to cancel channel pairs, you can use the
[SEL] buttons on the top panel or access the Pair/Grup pages.
Non-linked parameters
Input patches
Insert patches
Output patches
Comp insert position
Phase
Delay on/off
*
Delay time
Delay feedback
Delay mix
Routing
Pan, Follow Pan
Surround pan
Aux Send pan
Balance
**
Attenuators