Yamaha DM1000 Owner's Manual page 237

• Rx PORT .......................This parameter specifies a port for general MIDI data recep-
• Tx PORT........................This parameter specifies a port for general MIDI data transmis-
B
MIDI THRU section
These parameters enable you to route incoming MIDI data from one port to another
without changes. Select a port for reception in the first parameter box, and select a port
for transmission in the next parameter box (located to the right of the arrow). If you
select USB, specify the port number in the small parameter box adjacent to the port
parameter box.
C
MACHINE CONTROL section
This section enables you to select a remote control method and a remote control port to
control external devices, including hard disk recorders and video equipment.
• TYPE..............................Specify a type (method) of remote control by turning on either
• PORT .............................Select MIDI, USB, REMOTE, or SLOT (available only when an
• DEVICE ID ...................Specify the DM1000's MMC Device ID. MMC Device IDs
D
SPECIAL FUNCTIONS section
This section enables you to specify ports for various special functions.
• Studio Manager............In the left parameter box, select MIDI, USB, or REMOTE as the
• DAW...............................Select USB or REMOTE as a port for use with a DAW. If you
• REMOTE 1 ....................This parameter indicates the target currently selected for
• REMOTE 2 ....................This parameter indicates the target currently selected for
• CASCADE LINK ..........Select MIDI or REMOTE as a port for DM1000 cascade con-
tion. In the left parameter box, select MIDI, USB, or SLOT
(available only with an optional mLAN card installed). If you
select USB, specify the port number in the right parameter box.
sion. The available ports are the same as for the Rx PORT
parameter.
the MMC (MIDI Machine Control) button or the P2 (Sony P2
protocol) button.
optional mLAN card is installed) for MMC command transfer.
If you select USB, specify the port number in the right param-
eter box.
identify connected devices, enabling recognition during MMC
transmission and reception.
port used by the included Studio Manager software. In the two
small parameter boxes on the right, specify a port number (if
you selected USB), and an ID number.
select USB, specify in the right parameter box a port number
pair (1–2, 3–4, 5–6, 7–8).
Remote Layer 1. If the target is set to "USER DEFINED," you
can select a MIDI message destination port.
Remote Layer 2. If the target is set to "USER DEFINED," you
can select a MIDI message destination port.
nection. Clicking the TRANSMIT button during cascade con-
nection enables you to copy the internal settings of the
DM1000 you are operating to another DM1000. This enables
both DM1000s to share the identical parameter settings. Click-
ing the REQUEST button during cascade connection enables
you to copy the internal settings of the other DM1000 to the
DM1000 you are operating.
237
MIDI Port Setup
DM1000—Owner's Manual
18