Bus Out 1-8 - Yamaha DM1000 Owner's Manual

80
Chapter 7—Bus Outs
Bus Out 1–8
The Bus Out 1–8 section mixes signals routed from Input Channels to the specified buses,
processes them using on-board EQ, compressor, etc., then routes them to the specified out-
put connectors or I/O cards.
The following diagram illustrates the Bus Out signal flow.
• INSERT
• ATT (Attenuator)
• 4 BAND EQ (4-band equalizer)
• COMP (Compressor)
• ON (On/Off)
• LEVEL
• OUTPUT DELAY (Output delay)
• METER
The parameters and sections listed above are identical to those for the Stereo Out. For more
information, refer to the explanation the Stereo Out (see page 79).
• Bus to Stereo
Bus Out 1–8 signals are also routed to the Stereo Bus. In addition to the ON, LEVEL, and
other parameters, you can also set the Send Level, On/Off, Pan, and other parameters.
Tip: You can also pair adjacent odd-even buses (in this order) for stereo operation (see
page 87).
Note: By default, channels 1–8 and 9–16 of Slots 1 and 2 are patched to the Bus Out 1–8
outputs. However, you can change this patching on the Output Patch page.
DM1000—Owner's Manual
(Gain Reduction) (Out Meter)
METER METER
COMP
INSERT
INSERT
METER
ON
4BAND
ATT
EQ
PAN
METER
INSERT
LEVEL
OUTPUT
DELAY
ON
LEVEL
BUS to STEREO
BUS 1(...8)
TO INPUT PATCH
BUS 1(...8)