Gating Input Channels - Yamaha DM1000 Owner's Manual

62
Chapter 6—Input Channels
C
Channel section
You can set individual delay parameters here. The delay parameters include the follow-
ing items:
• msec............................... This parameter sets the delay time in milliseconds.
• meter/feet/sample/
beat/frame .................... The delay time can be set using units of meters, feet, samples,
• MIX................................ This parameter sets the mix balance of dry (Input Channel)
• FB.GAIN ....................... This parameter sets the amount of delay feedback.
Tip:
• The delay time range depends on the sampling rate at which the DM1000 is operating. (For
example, at 44.1 kHz, the range is 0 through 984.1 msec.)
• If you select the DELAY SCALE meter or feet button, the distance value can be converted to
the delay time based on sonic speeds (about 340 m/sec at 15 degrees Celsius). This option is
useful if you wish to correct the timing difference between two sound sources that are far
apart.
• If you select the DELAY SCALE beat button, a parameter box for setting a note that repre-
sents the beat and a parameter box for a tempo (BPM) setting appear below the DELAY
SCALE parameter. Setting the note and BPM settings in these parameter boxes enables you
to set a delay time that synchronizes to the song tempo.

Gating Input Channels

To set the Input Channel gates, use the [SEL] buttons to select the desired Input Channel,
then press the DISPLAY ACCESS [DYNAMICS] button, then the [F1] button. The Dynam-
ics | Gate Edit page appears.
A
KEYIN SOURCE
Select one of the following buttons to determine the trigger source for the cur-
rently-selected Input Channel's gate.
• SELF............................... The selected channel's own input signal is the trigger source.
• CHANNEL.................... Another Channel's input signal is the trigger source. Select the
• AUX ............................... An Aux Send signal is the trigger source. Select the desired bus
DM1000—Owner's Manual
beats, or frames, which you select by using the DELAY SCALE
buttons.
and wet (delayed) signals.
2
1
6
desired channel in the parameter box below the CHANNEL
button.
in the parameter box below the AUX button.
3
4
5
7