Channel Strip Section; Stereo Section - Yamaha DM1000 Owner's Manual

Channel Strip Section

A Encoders 1–16
1
These rotary Encoders adjust the channel parameter settings. Depending on the button
selected in the ENCODER MODE section (see page 16), the Encoders will adjust the chan-
2
nel pan setting (when the ENCODER MODE [PAN] button indicator is lit), the AUX Send
SEL
level (when the ENCODER MODE [AUX] button indicator is lit), or any parameter (when
3
the ENCODER MODE [ASSIGN] button indicator is lit).
SOLO
4
These Encoders also feature push switches that are used to view the value of the parameter
ON
currently assigned to the Encoder, or to punch in or out during Automix recording.
1
B [SEL] buttons 1–16
These buttons enable you to select desired channels. The [SEL] button indicator for the cur-
+10 0
rently-selected channel lights up. The channel selected by each [SEL] button depends on the
5
5
currently-selected button in the LAYER section (see page 20).
0
10
These buttons also allow you to select channels for Automix recording and playback, create
5
15
or cancel channel pairs, and add channels to (or remove them from) Fader, Mute, EQ, and
20
10
Compressor groups.
15
30
C [SOLO] buttons 1–16
20
40
These buttons solo the selected channels. The [SOLO] button indicator of the cur-
50
30
60
40
70 rently-soloed channel lights up.
50
5
D [ON] buttons 1–16
These buttons turn the selected channels on or off. The [ON] button indicators for On
1
17 33
channels light up.
1
AUX
E Channel faders 1–16
These are touch-sensitive 100 mm motorized faders. Depending on the button selected in
the FADER MODE Section (see page 16), the faders will adjust the input or output level of
the selected channels or buses, or adjust the AUX Send level.

STEREO Section

A [AUTO] button
1
When this button is turned on, you can use the [SEL] buttons 1–16 to turn the Automix
AUTO
2 function on or off.
SEL
B [SEL] button
3
Selects the Stereo Bus.
ON
C [ON] button
Turns the selected bus on or off.
0
D [STEREO] fader
5
This touch-sensitive 100 mm motorized fader adjusts the final output level of the Stereo
10
Bus.
15
20
30
40
50
60
70
4
STEREO
15
Control Surface
DM1000—Owner's Manual
2