Punching In & Out - Yamaha DM1000 Owner's Manual

188
Chapter 16—Automix
Punching In & Out
You can modify part of a recorded Automix or add events to an Automix (Punch In & Out).
You can punch in and out channels using the [SEL] buttons, or individual parameters using
other controls.
Punch In & Out Using the [SEL] Buttons
Follow the steps below to punch channels in and out using the [SEL] buttons.
1 Select parameters you wish to record in the OVERWRITE section.
2 Move the cursor to the REC or AUTO REC button at the bottom of the page,
then press [ENTER].
3 Press the [AUTO] button.
The button indicator lights up. At this time, make sure that the [SEL] button indicators for
all channels (including the channels you want to punch in) are lit green.
4 Start the timecode source.
The REC and PLAY buttons are highlighted and parameter event recording is armed. How-
ever, no events are yet recorded since no channels are selected.
5 To punch in channels, press the corresponding [SEL] buttons.
The corresponding [SEL] button indicators light up red and the channels are placed in
record mode.
Note: If the punch-in channels already contain the parameter events selected in the OVER-
WRITE section, punching-in immediately overwrites the existing events. Be careful while
selecting parameters in the OVERWRITE section so that you will not delete events you wish
to retain.
6 Adjust the controls of the selected channels.
7 To punch out the channels, press the corresponding [SEL] buttons again.
8 Stop the Automix.
A confirmation window regarding updating the Automix data appears.
Tip: You can also select the recording channels first using the [SEL] buttons, start the timecode
source, then select the desired parameters in the OVERWRITE section to punch in and out.
Punching In & Out Individual Events
Even if you selected some parameters in the OVERWRITE section, you can punch in an
individual parameter by following the steps below:
1 In the OVERWRITE section, select the parameters you want to record.
2 Move the cursor to the REC or AUTO REC button at the bottom of the page,
then press [ENTER].
3 Press the [AUTO] button on the top panel.
The button indicator lights up. Make sure that the [SEL] button indicators for all channels
are lit green.
4 Start the timecode source.
The REC and PLAY buttons are highlighted and event recording is armed. However, no
events are yet recorded since no channels are selected.
DM1000—Owner's Manual