Yamaha DM1000 Owner's Manual page 314

314
Appendix A: Parameter Lists
COMP 5.1
Six input, six output compressor for 5.1 surround, with individual solo for each band, and
gain reduction metering of left and right (L+R), left surround and right surround (LS+RS),
center (C), or LFE channels.
Parameter
LOW GAIN
MID GAIN
HI. GAIN
PRESENCE
THRE.
RATIO
ATTACK
RELEASE
KNEE
LOOKUP
KEY LINK
L–M XOVR
M–H XOVR
SLOPE
CEILING
SOLO LOW
SOLO MID
SOLO HIGH
1. 6 ms–46.0 s (fs=44.1 kHz), 5 ms–42.3 s (fs=48 kHz), 3 ms–23.0 s (fs=88.2 kHz), 3 ms–21.1 s
(fs=96 kHz)
2. 5.1: Key-in's of all inputs are linked
5.0: Key-in's of L, C, R, LS, and RS are linked (LFE is independent)
3+2: Key-in's of L, C, and R, and key-in's of LS and RS, are linked respectively (LFE is independent)
2+2: Key-in's of L and R, and key-in's of LS and RS, are linked respectively (C and LFE are independent)
DM1000—Owner's Manual
Range
–96.0 to +12.0 dB Low band level
–96.0 to +12.0 dB Mid band level
–96.0 to +12.0 dB High band level
For positive values, the threshold of the high band is lowered
and the threshold of the low band is increased. For negative
–10 to +10
values, the opposite will occur. When set to 0, all three bands
are affected the same.
–24.0 to 0.0 dB Compressor threshold
1:1 to :1 Compressor ratio
0–120 ms Compressor attack
1
Compressor release time
0–5 Compressor knee
0.0–100.0 ms Lookup delay
2
Key-in linking
21.2 Hz–8.00 kHz Low/mid crossover frequency
21.2 Hz–8.00 kHz Mid/high crossover frequency
–6 to –12 dB Filter slope
–6.0 to 0.0 dB, OFF Specifies the maximum output level
OFF, ON If this is on, only the low-frequency band will be output.
OFF, ON If this is on, only the mid-frequency band will be output.
OFF, ON If this is on, only the high-frequency band will be output.
Description