Yamaha DM1000 Owner's Manual page 139

• (SW Phase) button ..................... This button reverses the phase of the signal out-
2 Make sure that the Speaker button (
to output the Oscillator signal is turned on.
If the button is off, move the cursor to the button, then press [ENTER] to turn it on.
3 Move the cursor to the OSC. parameter box, then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to select one of the following Oscil-
lator waveforms.
• PINK NOISE.................Pink noise
• 500–2 kH .......................Pink noise through a 500 Hz to 2 kHz BPF
• 1 kHz..............................1 kHz sinewave
• 50 Hz..............................50 Hz sinewave
4 Move the cursor to the ON/OFF button, then press the [ENTER] or
[INC]/[DEC] buttons to turn the Oscillator on.
The speaker specified in Step 2 outputs the Oscillator signal. If necessary, adjust the speaker
volume balance in the MONITOR ALIGNMENT section on the Surr Setup page (see
page 136).
Patching Slot Inputs to Surround Channels
You can patch individual Slot Inputs to Surround Monitor Channels as follows.
1 Make sure that the DM1000 is in the same Surround mode as the monitoring
source.
2 Press the MONITOR [SLOT] button.
Slot 1 or 2 Input is selected as the surround monitor source.
3 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Surr
Patch page appears.
This page enables you to make the Slot Input to Surround Monitor Channel assignment.
4 Move the cursor to a patch parameter for which you want to change the
assignment, and rotate the Parameter wheel to select a slot channel to be
assigned to the Surround Monitor channel.
To assign no channels, select "–." Set all unnecessary channels to "–."
Surround Monitoring
put to the Subwoofer (SW).
) for the speaker to which you want
DM1000—Owner's Manual
139
11