Punching In & Out Individual Parameters - Yamaha 02R96 Owner's Manual

Punching In & Out Individual Parameters
During Automix rerecording, channels can be punched in and out by pressing the channel
strip [AUTO] buttons. Individual parameters can be punched in and out as follows.
Parameter
Input
Bus Out, Aux
Send
Channel Levels
(faders)
Stereo Out
Group Master
faders
Pan
Input
Surround Pan
Input
EQ (F, Q, G)
All channels
EQ On/Off
Aux send 1–8 levels
Input
Effect parameters
Effects proces-
(certain parameters)
sors 1–4
User Defined Plug-Ins
Plug-Ins 1–4
(parameters 1–4)
Faders
User Defined Remote
Layers
Encoders
1. TOUCH SENSE on Fader Edit page must be TOUCH or LATCH.
2. TOUCH SENSE on Fader Edit page must be TOUCH.
If during Automix recording you punch in an individual parameter by using the controls
listed in the above table, even if some OVERWRITE buttons are on, only the existing data
of that particular parameter will be overwritten. Likewise, when you punch out an individ-
ual parameter by using the controls listed above, only that particular parameter will be
punched out.
If during Automix recording you press an [AUTO] button to punch in a channel, the exist-
ing data of all parameters for which the corresponding OVERWRITE buttons are on will be
overwritten. When you press the [AUTO] button to punch out of recording, all of those
parameters will be punched out.
OVER-
Channel
WRITE
Set Layer to input, Fader mode to
Fader
Set Layer to Master, Fader mode
to fader
FADER
Stereo Out fader
Set the Fader mode to Fader; Set
the Group Master in the User
Assignable Layer.
Set Layer to input, Encoder mode
PAN
to Pan.
Select Input Layer and assign Sur-
SURR round LFE Level or Surround Pan
Wheel to the Encoders
Turn on Auto EQ Edit In prefer-
ence (see page 233). Use
EQ SELECTED CHANNEL EQUALIZER
section (If EQ parameter assigned
to an Encoder, also use Encoders)
Set Layer to input, Fader mode to
Aux
AUX
Set Layer to input, Encoder mode
to Aux
— Select internal effects processors
— Select Plug-Ins
FADER Select User Defined Remote Layer
PAN Select User Defined Remote Layer
Punching In & Out Individual Parameters
Operation
Touch fader knob
and adjust
Press Encoder
and adjust
Press Encoder
and adjust
Adjust control
Press EQ [ON]
button
Touch fader knob
and adjust
Press Encoder
and adjust
Push Parameter
1–4 control, or
select the param-
eters on the Effect
Edit page, then
press [ENTER]
Push Parameter
1–4 control.
Select the desired
parameter on the
Plug-in Edit page,
then press
[ENTER]
Touch fader knob
and adjust
Press Encoder
and adjust
183
Punch In Punch Out
Release fader
1 2
knob
Press Encoder
Press Encoder
Press [AUTO] but-
ton
Press [AUTO] but-
ton
Release fader
1 2
knob
Press Encoder
Push Parameter
1–4 control, or
select the param-
eters on the Effect
Edit page, then
press [ENTER]
Push Parameter
1–4 control Select
the desired
parameter on the
Plug-in Edit page,
then press
[ENTER]
Release fader
1 2
knob
Press Encoder
02R96 Version 2—Owner's Manual