How To Use This Manual - Omron ZX-E Operation Manual

How to Use This Manual

Page Format
Adjusting Linearity
ZX-E Smart Sensor linearity is adjusted before shipment, however
more accurate linearity can be obtained by adjusting linearity again
for the actual sensing objects and operating environment.
Selecting Sensing Object Material
This section describes how to set the sensing object material.
To use the default linearity adjustment after changing materials,
select the material and then select Adjust.
Changing to T Mode
Set the mode switch to T.
Set the switch to the threshold value to
be set.
Press any Cursor Key.
The first digit of the threshold value displayed on
the sub-display will flash and direct input will be
enabled.
Change the threshold value with the Cursor
Keys.
To cancel the selected setting, use the LEFT
Key to move the cursor to the leftmost digit
and press the LEFT Key again. he display will
return to the current setting.
Procedure and Additional Explanations
Information useful during the operation and reference
pages are provided here with special marks to indicate the
kind of information being provided.
Section 3
Basic Operations
ZX-E
Operation Manual
Display Area
Shows the display status after
a step in an operation.
Keys and Switches
Provides an illustration of the keys or
switches used during the operation.
* This page does not actually exist in
this manual.
PREFACE
Section Title
Main Heading in
a Section
Indicates page contents.
Outline
Provides an outline or gives a
flowchart of the operation de-
scribed under the main heading.
Sub-heading
Index Label
Gives the section number and
subject matter.
Function Outline and
Suggestions
Operation
Indicates the operation to be
performed next.
Operation Manual
ZX-E
13