Section 2
PREPARATIONS FOR MEASUREMENT
Installing Sensor Heads
This section describes how to install Sensor Heads and Preamplifiers.
Sensor Heads
Installation
ZX-ED@@T Sensor Heads (Non-threaded Type)
Mounting Bracket (order separately)
Y92E-F5R4 (for 5.4 mm dia.)
When using a set screw, tighten the screw to a torque of 0.2 N ⋅ m or less.
Mount the Sensor Head as shown in the following diagram.
Set screw hole
ZX-EM@@T Sensor Heads (Threaded Type)
The tightening torque for the threaded type (ZX-EM@@T) is shown in the following
table.
ZX-E
30
Operation Manual
Model
ZX-EM02T
ZX-EM07MT
ZX-EM02HT
When using the ZX-EM02HT, consider the thermal expansion caused by the rise in temperature
of the sensing object, and make sure that the sensing object does not touch the sensing surface.
Even when operated within the specified temperature range, using in locations subject to
extreme temperature fluctuations may result in deterioration of Sensor characteristics.
When using the ZX-EM02HT, make sure that the bending radius of the cable from the Sensor
Head is 8 mm or greater .
Model
ZX-EDR5T
9 to 18
ZX-ED01T
9 to 18
ZX-ED02T
11 to 22
Strength
(torque)
15 N·m
5.9 N·m
(Unit: mm)
A