Omron ZX-E Operation Manual page 113

6.
Use the LEFT and RIGHT Keys to display
RESET on the main display.
Selecting Output Status for Non-measurement
7.
Press the UP or DOWN Key.
The sub-display will flash.
8.
Use the UP and DOWN Keys to select either
KEEP or CLAMP.
9.
Press the ENT Key to confirm the selection.
The output status will be registered.
Next, set the clamp value if CLAMP is selected.
Setting Clamp Values (when CLAMP Is Selected)
10.
Use the LEFT and RIGHT Keys to display
CLAMP on the main display.
CLAMP cannot be displayed if KEEP has been selected.
11.
Press the UP or DOWN Key.
The sub-display will flash.
12.
Select the clamp value.
13.
Press the ENT Key to confirm the settings.
The clamp value will be registered.
Section 5
DETAILED SETTINGS
ZX-E
Operation Manual
111