Adjusting Linearity; Selecting Sensing Object Material - Omron ZX-E Operation Manual

Section 3
BASIC OPERATION

Adjusting Linearity

ZX-E Smart Sensor linearity is adjusted before shipment, however more accurate linearity can
be obtained by adjusting linearity again for the actual sensing objects and operating
environment.
Adjust linearity before setting measurement conditions. Linearity should also be adjusted
again when Sensor Heads are replaced.
Flow of Operation
Selecting Sensing
Object Material
Linearity

Selecting Sensing Object Material

This section describes how to set the sensing object material.
Selection
FE (default)
SUS
AL
Linearity According to Material
Characteristic Data, p. 148
To use the default linearity adjustment after changing materials, select the material and then perform
ZX-E
54
Operation Manual
Entering Adjustment
Values
p. 139
Material
Iron
Stainless steel (SUS304)
Aluminum
Executing Adjustment.
Executing Adjustment