Related Manuals for Omron ZX2 Series
Summary of Contents for Omron ZX2 Series
- Page 1 Short Manual ZX2 Short Manual.doc Page 1 of 12...
- Page 2 1 Safety precautions and correct use Please refer to the full ZX2 user manual for the detailed explanations of the safety precautions and the correct use. 2 Wiring Calculation unit (required for systems with 2 or more amplifiers) Amplifier Extension cable (optional, max.
- Page 3 3 Default Measurement range ZX2-LD50(L) ZX2-LD100(L) 50mm Display: -10.000 10mm 0.000 100mm 10mm +10.000 Display: -35.000 35mm 0.000 35mm +35.000 The analog output line can be set to following default ranges (see p.11 and p.12 for additional settings): ZX2-LD50 ZX2-LD100 -5…5V 1V…5V 4mA…20mA...
- Page 4 4 Display in RUN mode Orange subdisplay Press right or left button Displays the selected bank Displays the High Threshold Displays the Low Threshold Displays either the current or voltage at the analog output Displays the current resolution Displays the current measurement value ZX2 Short Manual.doc Page 4 of 12...
- Page 5 5 Functions in RUN mode: ZERO LED turns on Set the current value to ZERORESET Press the “down arrow” button for 3 seconds. In order to switch off again, press the up- and down arrow simultaneously for 3 seconds. Activate the Key Lock. Press both “arrow left”...
-
Page 6: Setup Mode
6 Setup mode Pressing and holding the “MENU/SET” button for 3 seconds changes the mode of the amplifier to the setting mode (pressing again for 3s moves back to RUN mode): MENU LED Indicates setup mode Press for 3 seconds Below you see the navigation through all menus (Details switched on, all other options switched off) by pressing the left/right arrow button. - Page 7 Setup the Hysteresis. Detail Bank Setup the scale of the display and analog output value. (All settings (S1/S2) for the scaling are stored in the bank data. See p. 11.) Detail Bank Setup the Hold function. See p. Detail Setup of the analog output either voltage or current and the output range.
- Page 8 Setup the on-delay of the digital outputs. See the full user manual for details. Detail Setup the off-delay of the digital outputs. See the full user manual for details. Detail Setup the way how the zero-reset value is stored (permanently or volatile).
-
Page 9: Smart Tuning
7 Smart Tuning Smart Tuning sets the optimum parameters for the chosen response time (“Speed” setting) and the measurement object automatically. The ZX2 has 3 different Smart Tuning modes: Single Smart Tuning: Single Smart Tuning is used if the objects in the final application always have the same surface characteristic. - Page 10 8 Hold (=trigger) functions The hold function is used to hold a certain measurement value while a certain sampling period. After the sampling period has passed this value is displayed and applied at the analog output. The possible methods are “Average”, “Peak to Peak” (=maximum-minimum), “Sample”, “Bottom”...
- Page 11 9 Scaling The scaling function is used to both 1. adjust the display value. 2. adjust the analog output value. With scaling it’s possible to set the values for the upper and lower measurement range limits: The easiest way to understand how the setting is done is using an example: The default range of the sensor is +/-10 mm (e.g.
- Page 12 10 Setting for the analog output in case of measurement error If no measurement is possible, e.g. because no object is in front of the sensor inside of the measurement range (display: E-dark), the sensor can be configured for the analog output either to issue: ...