Section 4
MAIN APPLICATIONS AND SETTING METHODS
Adjusting Setting Distances
Set a reference sample with a known thickness (T).
Adjust the Sensor Heads so that the distances between the reference sample and the
Sensor Heads (A and B) are each about half the measurement distance. Refer to the
Amplifier Unit display when adjusting the Sensor Heads.
Measurement distance, p. 143
Preventing Mutual Interference
Mutual interference prevention settings are required when the distance between Sen-
sor Heads is less than the mutual interference distance.
These settings are not required if the Sensor Heads are further apart than the mutual
interference distance.
For information on mutual interference distance, refer to Mutual Interference, p. 32.
The settings are made on the CH1 Amplifier Unit. Refer to Section 6 Auxiliary Func-
tions for details on settings.
Preventing Mutual Interference between Sensors, p. 120
ZX-E
76
Operation Manual
Setting distance