Omron CX-PROGRAMMER V9 Operation Manual page 86

OMRON
Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
C-Series
NSJ-Series
FQM-Series
IDSC
SRM1
SRM1
Note:
Refer to the CX-Server PLC Tools User Manual for information regarding available communication types.
System Requirements
System Requirements
CX-One Setup Manual
Refer to the
Programmer on a computer.
Memory Capacity
The required RAM depends on the size of the programs that are created. For each Kstep of PLC
programming, approximately 2 Mbytes of available RAM is required. If more than one PLC is
registered in a project, the total RAM for the programs for all of the PLCs is required.
Examples:
Program size
30 Ksteps or less
120 Ksteps or less
400 Ksteps or less
Model
C2000H
C200H
C200HE
C200HE-Z
C200HG
C200HG-Z
C200HS
C200HX
C200HX-Z
CPM1
(CPM1A)
CPM2*
CPM2*-S*
CQM1
CQM1H
NSJ
FQM-CM
FQM-MMA
FQM-MMP
–
SRM1
SRM1-V2
The CVM1-V1 PLC for types CPU01 and CPU11 cannot be specifically selected. Use the non
V2 types.
(Cat. No. W463) for the system requirements to install the CX-
Recommended available memory
60 Mbytes min.
240 Mbytes min.
800 Mbytes min.
CPU 01
CPU 01, CPU 02, CPU 03, CPU 11, CPU 21, CPU 22, CPU 23, CPU 31
CPU 11, CPU 32, CPU 42
CPU 11, CPU 32, CPU 42
CPU 33, CPU 43, CPU 53, CPU 63
CPU 33, CPU 43, CPU 53, CPU 63
CPU 01, CPU 03, CPU 21, CPU 23, CPU 31, CPU 33
CPU 34, CPU 44, CPU 54, CPU 64
CPU 34, CPU 44, CPU 54, CPU 64, CPU 65, CPU 85
CPU 10, CPU 20, CPU 30, CPU 40
–
CPU 11, CPU 21, CPU 41, CPU 42, CPU 43, CPU 44, CPU 45
CPU 11, CPU 21, CPU 51, CPU 61
G5D (Used for the NSJ5-TQ0*-G5D, NSJ5-SQ0*-G5D, NSJ8-TV0*-G5D,
NSJ10-TV0*-G5D, and NSJ12-TS0*-G5D)
FQM1-CM001/002
FQM1-MMA21/22
FQM1-MMP21/22
–
C01, C02
C01, C02
PART 1: CX-Programmer
CHAPTER 1 – Technical Specifications
CPU Types
CX-Programmer _Page 3