Omron CX-PROGRAMMER V9 Operation Manual page 353

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links
Changing Node Refresh Sequences
The node refresh sequence set for each node by the Datalink Wizard can be changed in the Node Editing window.
In the Node Editing window, select the node for which the refresh sequence is to be changed.
Change the node refresh sequence by either clicking F4: Move Up Area or F5: Move Down Area in
F5: Move
the Function Bar, or pressing the F4 or F5 function keys.
Down Area
Reference: The node refresh sequence for individual nodes cannot be checked in the Data Link
Adding Participating Nodes to Data Links
In the Node Editing window, it is possible to add nodes aside from the participating nodes set by the Datalink
Wizard's Network Nodes setting.
The following window is displayed by selecting Table | Add Source Node from the Datalink Component menu
or by clicking the
Specify the node address, PLC type, and the Area 1 and Area 2 memory areas, and then click the OK button.
CX-Server PLC Tools_Page 110
Configuration window. Node refresh sequence checking and changes must be
performed in the Node Editing window.
button in the Toolbar.
OMRON