Omron CX-PROGRAMMER V9 Operation Manual page 24

CJ1-H/CJ1M CPU Units (CJ1@-CPU@@H, CJ1M-CPU@@)
Function
Function blocks (supported for CX-Programmer Ver.
5.0 or higher)
Serial Gateway (converting FINS commands to
CompoWay/F commands at the built-in serial port)
Comment memory (in internal flash memory)
Expanded simple backup data
Additional PRV(881) and PRV2(883)
instruction instructions: Added high-frequency
functions calculation methods for calculating
pulse frequency. (CJ1M CPU Units
only)
New TXDU(256), RXDU(255) (support
application no-protocol communications with
instructions Serial Communications Units with
unit version 1.2 or later)
Model conversion instructions:
XFERC(565), DISTC(566),
COLLC(567), MOVBC(568),
BCNTC(621)
Special function block instructions:
GETID(286)
Additional TXD(235) and RXD(236)
instruction instructions (support no-protocol
functions communications with Serial
Communications Boards with unit
version 1.2 or later)
New ASCII conversion instructions
application (NUMBER-To-ASCII and ASCII-
instructions TO NUMBER)
Improved Online editing of function blocks
function block
Input-output variables are
(FB) functions
supported. (Input-output variables
can be specified in arrays.)
The STRING data type and text-
string processing functions are
supported in ST language.
Using ST language programming in tasks
Using SFC programming in tasks
Note: CX-Programmer version 7.0 or higher is required to use functions added for unit version
4.0. Additional functions are supported if CX-Programmer version 7.2 or higher is used.
Pre-Ver. 2.0,
Ver. 2.0
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
Unit version
Ver. 3.0
(See note.)
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK with CX-
Programmer Ver. 7.2
or higher
OK with CX-
Programmer Ver. 7.2
or higher
CX-Programmer_Page (
Ver. 4.0
xxi
)