Procedure Using Setup Example - Omron CX-PROGRAMMER V9 Operation Manual

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links

Procedure Using Setup Example

Set Area 1 for each node, based on the data link setup example in the example system configuration.
Setting Node Address 01
1 Select node address 01 from the node address list on the left. Node 01 will be highlighted.
The data link table for node address 01, the node to be edited, is displayed as a list in the Node Editing window on
the right.
Local node send area
Receive area from
remote nodes
Reference: With node address 01, the node refresh sequence matches the default (order of
2. With node address 01, the node refresh sequence matches the default (order of addresses), so no change is
required.
With node address 01, the size and offset are both automatically displayed as the defaults, so no changes are
required.
Settings for area 2 are made using the same method.
CX-Server PLC Tools_Page 112
Note: The receive size and reception offset can only be set for Controller Link, and not for
SYSMAC LINK.
Select node address 01 as the object to be edited.
Indicates the node refresh
sequence. (In this example,
for node address 01, no
change is required.)
addresses), so no change is required.
With node address 01, the size and offset are both automatically displayed as the
defaults, so no changes are required.
The data link data for the selected node
address is displayed here.
Sends 30 words from the local node (node address
01), starting with CIO 01000 (i.e., CIO 01000 to CIO
01029).
Receives 30 words from node 02, starting with
CIO 01230 (i.e., CIO 01230 to CIO 01259) into
the local node area starting with CIO 01030
(i.e., CIO 01030 to CIO 01059).
Receives 40 words from node 03, starting with
CIO 00350 (i.e., CIO 00350 to CIO 00389) into
the local node area starting with CIO 01060
(i.e., CIO 01060 to CIO 01099).
The size and offset can be set.
Automatically displayed.
OMRON