Omron CX-PROGRAMMER V9 Operation Manual page 25

Functions Supported by Unit Version for CJ2 CPU Units (CJ2H-CPU6@-EIP, CJ2H-
CPU6@)
Functions Added for Unit Version 1.3
Unit Version 1.2 or Later
Unit Version 1.1 or Later
CX-Programmer version 9.1 or higher is required to use functions added for
unit version 1.3.
CPU Units
Models
Function
Special instructions for
specific CPU Bus Units
New special
instructions
CX-Programmer version 8.3 or higher must be used to enable using the
functions added for unit version 1.2.
Unit
Model
Item
EM Area force-setting/resetting
CX-Programmer version 8.1 or higher must be used to enable using the
functions added for unit version 1.1.
Unit
Model
Item
High-speed interrupt function
Decreased overhead time for interrupt tasks
Minimum interval setting of 0.1 ms for Scheduled
Interrupt Task
Changing the minimum cycle time setting in
MONITOR mode
Synchronous unit operation
Unit version
CJ1W-NC281/NC481/NC881
Position Control Units:
PCU HIGH-SPEED POSITIONING
(NCDMV(218))
CJ1W-NC281/NC481/NC881
Position Control Units:
PCU POSITIONING TRIGGER
(NCDTR(219))
SIGNED AREA RANGE COMPARE
(ZCPS(117))
DOUBLE SIGNED AREA RANGE
COMPARE (ZCPSL(118))
Unit version
Supported.
Unit version Unit version 1.1
Supported.
Supported.
Supported.
CJ2H CPU Units
CJ2H-CPU6@-EIP
CJ2H-CPU6@
Unit version 1.3
Supported.
Supported.
Supported.
Supported.
CJ2H CPU Unit
CJ2H-CPU6@-EIP
CJ2H-CPU6@
Unit version 1.2
CJ2H CPU Unit
CJ2H-CPU6@-EIP
CJ2H-CPU6@
Unit version 1.0
Not supported.
Not supported.
Not supported.
CX-Programmer_Page (
xxii
)