Omron CQM1 Operation Manual page 188

Specifications
Sensor Specifications
The following table lists combinations of typical sensors that can be used in combination with each sensor
module.
E3X-MA11
Item Sensing
method
Feature Long sensing
distance
Model E32-T11L
Sensing distance 500 mm
(standard sensing (1,200 mm)
object) (see note 1)
(1.4 dia. mm
min. non-trans-
parent object)
Minimum sensing 0.2 dia. mm
object (non-trans-
parent object)
Ambient operating –40 to 70 C with no icing
temperature
Ambient operating 35% to 85%
humidity
Permissible bending 25 mm min.
radius
Cable covering Black polyethylene
Enclosure rating IEC IP67
Note 1. Values in parentheses are possible if the E39-F1 Lens Unit is used.
2. The sensing distances of the E32T16 with slits are as follows:
0.5-mm wide slit: 450 mm with a minimum sensing object size of 0.2 mm dia.; 1.0-mm slit: 800 mm
with a minimum sensing object size of 0.3 mm dia.
3. The E32-T51 can be used continuously within a temperature range of –40 to 130 C.
Thru-beam model
Standard Flexible cable Long sensing
sensing
distance
E32-TC200 E32-T11
270 mm 240 mm
(2,000 mm) (1,300 mm)
(see note 1) (see note 1)
(1 dia. mm (1 dia. mm
min. non- min. non-
transparent transparent
object) object)
4 mm min.
Vinyl chloride
Side view Heat-resistive
thru-beam thru-beam
model model
Resisting
distance 150 C
E32-T14L E32-T51
130 mm ( 300 mm
1 dia. mm min. (1.5 dia. mm
non-transpar- min. non-trans-
ent object) parent object)
0.3 dia. mm 0.4 dia. mm
–40 to 150 C
with no icing
(see note 3)
25 mm min. 35 mm min.
Black polyeth- Fluorocarbon
ylene resin
Appendix A
Screen thru-
beam model
Sensing a
width of 10
mm
E32-T16
1,000 mm
(see note 2)
(view: 10 mm
wide) (10 dia.
mm min. non-
transparent
object)
0.2 dia. mm
(see note 2)
–40 to 70 C
with no icing
25 mm min.
Black polyeth-
ylene
169