Teaching - Omron CQM1 Operation Manual

Teaching

2-4 Teaching
Scaling Value Teach
Set Value Teaching
The teaching function is can be set only when the timing hold in operation
mode A is set to normal.
The Programming Console makes it possible to adjust the scaling and set val-
ues preset on the Unit using objects.
When the scaling value teach command is executed, the actual input value
can be set as the X1 or X2.
This allows an easy adjustment of the input error.
For example, when setting the X1 value as an input value of the smallest
object, execute a scaling command while the smallest object is being sam-
pled. In the same manner, the X2 value can be set as the largest object input
value if the scaling command is executed while the largest object is being
sampled.
Actual size
By using the set value teach command, an actual input value can be set as
the HH, H, L, or LL set value. It is useful for making judgments on whether
products are acceptable or defective.
For example, when setting the lowest set value LL, execute the set value
teach command while the smallest object is being measured. If the same
command is executed while the largest object is being measured, the highest
set value HH can be set.
Actual size
Section 2-4
Sensor input
Smallest object
X1 value
Adjustment value
Sensor input
Smallest object
LL set value
Adjustment value
187