Omron CQM1 Operation Manual page 178

Operation without CQM1-TU001 Remote Console
Teaching for Position
Control
1,2,3...
Note The sensor may not properly reset after detection when teaching detection of
subtle changes. Always check to be sure the sensor is resetting even if the
indicator shows that teaching is OK.
Teaching for position control is recommended when specifying the ON point
for the detection of objects which are too close.
1. Place the sensor head in the sensing range of the sensor.
2. Set the mode selector to SET.
3. Press the teaching button. The teaching indicator (orange) will be lit.
4. Move the object to the position where you want the output ON and press
the teaching button. If teaching is successful, the teaching indicator will
turn from orange to green.
5. Do not move the sensing object and press the teaching button a third time.
If teaching is successful, the teaching indicator will turn from green to or-
ange.
6. Set the mode selector to RUN to complete the sensitivity setting on the
E3X-MA11. If teaching is unsuccessful, the teaching indicator (orange) will
flash, in which case make sure that the sensor cable is connected, change
the position of the object and the sensing distance that have been set, and
repeat from step 3.
Note Teach within the stable sensing range. Although indicators may indicate that
teaching is OK even outside of this range, the sensor may not reset properly
after detection. Always check to be sure the sensor is resetting after teaching.
Section 4-1
l
l
l
ON point
159